This is Optimal Settings for Gsync per them- Gsync on, Vsync On in NVCP and set a Frame Rate Limiter 3 below (for 144hz set to 141FPS) it's at end of article. This way rogue misses of the frame rate target wont cause a distracting tear, but the majority of frames will be both untorn and immediately serviced by the display.Īs for power mode, I always set games to prefer maximum performance, go the cards don't down-clock below base when the driver thinks a game isn't sufficiently demanding., only to have dips when it suddenly is.Ĭheck out this article very good information. This is the solution I would recommend: Gysync on, Vsync on, Cap 98. Setting this slightly below your monitor's max refresh rate will ensure the monitor is always ready for a frame when it is presented, solving the input lag back pressuring issue, but at the cost of metering gpu output by tapering requested frames at the front. A good compromise has to do with one of your other questions, the FrameRateTarget. Which route you want to go with is up to you. If you are getting more frames than can be displayed, you'll get tearing but no back pressure of the pipe, and therefore no input lag spike. With vsync off, the GPUs will never wait on the monitor. With vsync on, you will never see tearing, but you will get an increase in input lag as you surpass your display's refresh rate and back pressure the pipeline. With Gsync enabled, the vsync setting determines what protocol will be used when your framerate exceeds your monitors refresh rate.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |